How to replace dishwasher cover panels
After a long time, it is common for a dishwasher cover panel to get a dent, crack, or a permanent damage, the front side being the most susceptible. When this takes place, you can replace instead of purchasing a new machine. Replacing any dishwasher accessory requires minimum tools and little skill. It just takes around an hour to finish.
Given below are the steps involved in replacing a dishwasher cover panel.
Purchase a pristine cover panel
The first act on your part is obtaining a pristine front dishwasher cover panel for the dishwasher that you have. In the event of you owning a somewhat recent model/make, you must not have any problem in placing an order for one at any of the hardware stores.
Cut off the power
Ahead of beginning, unplug your dishwasher or toggle the breaker that is responsible for powering it off.
Take the screws away
After the shutting down of the machine open the dishwasher cover. All along the rim, you’ll notice eight screws. Take these away using your screwdriver and leave them in a ziplock bag for keeping them secure as they will be needed later.
Take away the front cover panel
Though it’s easy to remove a dishwasher cover panel, you must be cautious. Place your hand on the front while closing the cover again. Make the dishwasher cover panel steady for ensuring that it doesn’t budge. On it falling off, there’s a possibility of it splitting cables that are attached inside.
Allow the dishwasher cover panel to gradually lean off the dishwasher as you hold onto it firmly. Subsequently, gradually raise it off and upward from your dishwasher. Be cautious that no wires are trapped in it.
Set up the pristine door
The pristine front is going to go in by the use of the door’s bottom rail. You must thrust it in such that it is completely flush. Ensure that no wires are caught up while moving it into position.
Keep a firm hold of the replacement while opening the dishwasher cover completely. Keep the firm hold while inserting all four corner screws. Once the screws are some way in, release the hold and make the screws tighter. After securing them, insert the additional four screws and make them tight.
